FavoriteToons.com Classifieds

June 24, 2019
Ad Details
Ad #
May 20, 2019
Orlando, Florida

This ad is no longer active
Report this ad: Wrong Category | Spam | Fraud
Seller Information
Member Level   Standard
Valid Email   Yes
Member Since: May 8, 2019
Country: United States
Active ads: 0

Get Adobe Flash player

Classified 5958928
Fix Sage Error Code 100 | Sage File System Error | +1 (800) 961-6588

The Sage Error Code 100 is typically a file system issue in file [filename]. If you are experiencing with the same error you can find methods to fix the error. The following lines highlight the causes and troubleshooting steps to resolve Sage Error Code 100.


When file attribute has been set to Read Only
Pervasive running as an application and not as a service
Pervasive file is corrupted or Pervasive cache isnít large enough
Damage file
Program has been installed on an external 32 bit program path
Specific company directory has damage file present.
User Account Control enabled

You can perform the following steps to fix your error. Contact the professionals at remoteaccounting247 if any assistance is required.

Solution I: When File attribute has been set to Read Only

When the error occurs, go through the error message and log in to the location that is mentioned in the message
Next, right-click the file then click on Properties
You need to clear the Read-only box located in Attributes section. Click on OK
Once this is done, try to open into the program once more. If the error continues, follow the next step
Solution II: When UAC is enabled

Right-click on the Sage icon
Next, select the option to run as an administrator
Solution III: Stop the Pervasive service and start again

Go to server and log in as an administrator.
Next click on the Start Search option and type in services.msc then click OK.
Locate the Pervasive or Actian PSQL Relational Engine.
When found, right click on it and choose Stop option
Repeat the steps for Pervasive or Actian PSQL Transactional Engine and the Sage Service/Host services
Next, right-click on each of the services and then click on Start option.
Solution IV: When program is installed on wrong directory

Note: If your system contains a program files -x86- directory, then the Sage program should be installed in the C drive Program Files -x86. If the program is located on different location it can cause issue such as Sage Error Code 100. You should uninstall the program and reinstall it in the correct path.

Uninstall your Sage program
Next. reinstall the Sage program to the default program path stated in the note above
Verify that you are able to open the company normally.
Solution V: Reboot computer

Reboot your system and try to open the program
Verify the error doesnít occur again
Other Solution

If the above resolution steps fail to fix your error, you can also attempt to:

Remove Pervasive and reinstall it
Rebuild the data path
Perform expendable file cleanup
Need more help?

Find more resolutions and assistance from experts by simply dialing on to our support number +1 (800) 961-6588. The RemoteAccounting247 professionals behind the helpline will help you fix your error in less time. You can also acquire our support service via Live Chat Support or by emailing us at ask@remoteaccounting247.com

Source: http://bit.ly/2WgYVZR

Share on Facebook

This ad has had 636 displays and 60 readers

[ Browse | Search | Account | Comments | Help ]

EPage manages over 37685 of the Web's classified sites
Read about our free Classified Service Provider (TM) Program.
Copyright © 1996-2010, EPage. All rights reserved. EPage and the mouse logo are registered trademarks of EPage